Internet-Draft | IKEv2 Optional Child SA&TS Payloads | July 2024 |
Kampati, et al. | Expires 8 January 2025 | [Page] |
This document describes a method for reducing the size of the Internet Key Exchange version 2 (IKEv2) CREATE_CHILD_SA exchanges used for rekeying of the IKE or Child SA by replacing the SA and TS payloads with a Notify Message payload. Reducing size and complexity of IKEv2 exchanges is especially useful for low power consumption battery powered devices.¶
This note is to be removed before publishing as an RFC.¶
Status information for this document may be found at https://datatracker.ietf.org/doc/draft-ietf-ipsecme-ikev2-sa-ts-payloads-opt/.¶
Discussion of this document takes place on the ipsec Working Group mailing list (mailto:[email protected]), which is archived at https://mailarchive.ietf.org/arch/browse/ipsec/. Subscribe at https://www.ietf.org/mailman/listinfo/ipsec/.¶
This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶
Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶
Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶
This Internet-Draft will expire on 8 January 2025.¶
Copyright (c) 2024 IETF Trust and the persons identified as the document authors. All rights reserved.¶
This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶
The Internet Key Exchange protocol version 2 (IKEv2) [RFC7296] is used to negotiate Security Association (SA) parameters for the IKE SA and the Child SAs. Cryptographic key material for these SAs have a limited lifetime before it needs to be refreshed, a process referred to as "rekeying". IKEv2 uses the CREATE_CHILD_SA exchange to rekey either the IKE SA or the Child SAs.¶
When rekeying, a full set of negotiation parameters are exchanged. However, most of these parameters will be the same as before, and some of these parameters MUST NOT change.¶
For example, the Traffic Selector (TS) negotiated for the new Child SA MUST cover the Traffic Selectors negotiated for the old Child SA. And in practically all cases, a new Child SA does not need to cover a wider set of Traffic. In the rare case where this would be needed, either a standard rekey could be used or a new Child SA could be negotiated followed by a deletion of the replaced Child SA.¶
Similarly, IKEv2 states that the cryptographic parameters negotiated for rekeying SHOULD NOT be different. This means that the security properties of the IKE or Child SA in practise do not change during a typical rekey.¶
This document specifies a method to omit these parameters and replace them with a single Notify Message declaring that all these parameters are identical to the originally negotiated parameters.¶
Large scale IKEv2 gateways such as Evolved Packet Data Gateway (ePDG) in 4G networks or Centralized Radio Access Network (cRAN/Cloud) gateways in 5G networks typically support more than 100,000 IKE/IPsec connections. At any point in time, there will be hundreds or thousands of IKE SAs and Child SAs that are being rekeyed. This takes a large amount of bandwidth and CPU power and any protocol simplification or bandwidth reducing would result in a significant resource saving.¶
For Internet of Things (IoT) devices which utilize low power consumption technology, reducing the size of the CREATE_CHILD_SA exchange for rekeying reduces its power consumption, as sending bytes over the air is usually the most power consuming operation of such a device. Reducing the CPU operations required to verify the rekey exchanges parameters will also save power and extend the lifetime for these devices.¶
When using identical parameters for the IKE SA or Child SA rekey, the SA and TS payloads can be omitted thanks to the optimization defined in this document. For an IKE SA rekey, instead of the (large) SA payload, only a Key Exchange (KE) payload and a new Notify Type payload with the new SPI are required. For a Child SA payload, instead of the SA or TS payloads, only an optional KE payload (when using PFS) and a new Notify Type payload with the new SPI are needed. This makes the rekey exchange packets much smaller and the peers do not need to verify that the SA or TS parameters are compatible with the old SA parameters.¶
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.¶
To indicate support for the optimized rekey negotiation, the initiator includes the OPTIMIZED_REKEY_SUPPORTED notify payload in the IKE_AUTH exchange request. If multiple IKE_AUTH exchanges are sent, the OPTIMIZED_REKEY_SUPPORTED notify payload should be in the last IKE_AUTH exchange. During this initial key request, the entire SA and TS payloads are included as normal. Note that the notify indicates support for optimized rekey for both IKE and Child SAs.¶
A responder that does not support the optimized rekey exchange processes the SA and TS payloads as normal, and does not include the new Notify. As per regular IKEv2 processing, a responder that does not recognize this new Notify, MUST ignore the notify. Responders may have been administratively configured with the optimization turned off for local reasons. The absense of the Notify indicates to the initiator that the optimization is not available, and normal, full rekey should be done.¶
When a peer wishes to rekey an IKE SA or Child SA, it MAY use the optimized rekey method during the CREATE_CHILD_SA exchange. If both peers have exchanged OPTIMIZED_REKEY_SUPPORTED notifies, peers SHOULD use the optimized rekey method for rekeys. Non-optimized, regular rekey requests MUST always be accepted.¶
The IKE_AUTH message exchange in this case is shown below:¶
Initiator Responder -------------------------------------------------------------------- HDR, SK {IDi, [CERT,] [CERTREQ,] [IDr,] AUTH, SAi2, TSi, TSr, N(OPTIMIZED_REKEY_SUPPORTED)} --> <-- HDR, SK {IDr, [CERT,] AUTH, SAr2, TSi, TSr, N(OPTIMIZED_REKEY_SUPPORTED)}¶
The initiator of an optimized rekey request sends a CREATE_CHILD_SA request with the OPTIMIZED_REKEY notify payload containing the new Security Parameter Index (SPI) for the new IKE SA. It omits the SA payload.¶
The responder of an optimized rekey request replies with an included OPTIMIZED_REKEY notify with its new IKE SPI and also omits the SA payload.¶
Both parties send their nonce and KE payloads just as they would do for a regular IKE SA rekey.¶
Using the old SPI from the IKE header and the two new SPIs respectively from the initiator and responder's OPTIMIZED_REKEY payloads, both parties can perform the IKE SA rekey operation.¶
The CREATE_CHILD_SA message exchange in this case is shown below:¶
Initiator Responder -------------------------------------------------------------------- HDR, SK {N(OPTIMIZED_REKEY,newSPIi), Ni, KEi} --> <-- HDR, SK {N(OPTIMIZED_REKEY,newSPIr), Nr, KEr}¶
The initiator of an optimized rekey request sends a CREATE_CHILD_SA request with the OPTIMIZED_REKEY notify payload containing the new Security Parameter Index (SPI) for the new Child SA. It omits the SA and TS payloads. If the current Child SA was negotiated with Perfect Forward Secrecy (PFS), a KEi payload is included as well. If no PFS was negotiated for the current Child SA, a KEi payload is not included.¶
The responder of an optimized rekey request performs the same process. It includes the OPTIMIZED_REKEY notify with its new SPI for the new Child SA and omits the SA and TS payloads. Depending on the PFS negotiation of the current Child SA, the responder includes a KEr payload.¶
Both parties send their nonce payloads just as they would do for a regular Child SA rekey.¶
Using the old SPI from the REKEY_SA payload and the two new SPIs respectively from the initiator and responder's OPTIMIZED_REKEY payloads, both parties can perform the Child SA rekey operation.¶
Notify payloads that can affect the Child SA properties, such as USE_TRANSPORT_MODE or ESP_TFC_PADDING_NOT_SUPPORTED MAY be sent but MUST be ignored and MUST NOT cause the Child SA properties to change. IPCOMP_SUPPORTED MUST be sent as it contains the required updated CPI parameter.¶
For the Child SA that was negotiated as part of an initial IKE exchange (eg IKE_AUTH), its rekey parameters for the KE payload SHOULD be the same KE group(s) for Child SA PFS as the negotiated IKE SA. If rekeying without PFS is required, the peer first initiates a regular Child SA rekey without KE payload, and subsequently it can use the optimized rekey method. If a peer responding to an optimized rekey receives a request with a non-allowed PFS proposal, it MUST return an INVALID_KE_PAYLOAD response.¶
The CREATE_CHILD_SA message exchange in this case is shown below:¶
Initiator Responder -------------------------------------------------------------------- HDR, SK {N(REKEY_SA,oldSPI), N(OPTIMIZED_REKEY,newSPIi), Ni, [KEi,]} --> <-- HDR, SK {N(OPTIMIZED_REKEY,newSPIr), Nr, [KEr,]}¶
The OPTIMIZED_REKEY_SUPPORTED Notify Message type notification is used by the initiator and responder to indicate their support for the optimized rekey negotiation.¶
1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +---------------+-+-------------+-------------------------------+ | Next Payload |C| RESERVED | Payload Length | +---------------+-+-------------+-------------------------------+ |Protocol ID(=0)| SPI Size (=0) | Notify Message Type | +---------------+---------------+-------------------------------+¶
Protocol ID (1 octet) - MUST be 0.¶
SPI Size (1 octet) - MUST be 0, meaning no SPI is present.¶
Notify Message Type (2 octets) - MUST be set to the value TBD1
.¶
This Notify Message type contains no data.¶
The OPTIMIZED_REKEY Notify Message type is used to perform an optimized IKE SA or Child SA rekey.¶
0 1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +---------------+-+-------------+-------------------------------+ | Next Payload |C| RESERVED | Payload Length | +---------------+-+-------------+-------------------------------+ |Protocol ID(=0)| SPI Size (=0) | Notify Message Type | +---------------+---------------+-------------------------------+ | | ~ New SPI ~ | | +---------------------------------------------------------------+¶
Protocol ID (1 octet) - MUST be 0.¶
SPI Size (1 octet) - MUST be 0. The "Security Parameter Index (SPI)" field is not used in this Notify, and the new SPI is placed in the "Notification Data" field.¶
Notify Message Type (2 octets) - MUST be set to the value TBD2
.¶
The 'New SPI' field is the data associated with this Notify, and it's either a four-octet SPI when rekeying an IKE SA or an eight-octet SPI when rekeying a Child SA.¶
This document defines two new Notify Message Types in the "IKEv2 Notify Message Types - Status Types" registry. IANA is requested to assign codepoints in this registry.¶
NOTIFY messages: status types Value ---------------------------------------------------------- OPTIMIZED_REKEY_SUPPORTED TBD1 OPTIMIZED_REKEY TBD2¶
Some implementations allow sending rekey messages with a different set of Traffic Selectors or cryptographic parameters in response to a configuration update. IKEv2 [RFC7296] states this SHOULD NOT be done. Whether or not optimized rekeying is used, a configuration change that changes the Traffic Selectors or cryptographic parameters MUST NOT use the optimized rekey method. It SHOULD also not use a regular rekey method but instead start an entire new IKE and Child SA negotiation with the new parameters.¶
The optimized rekey removes sending unnecessary new parameters that originally would have to be validated against the original parameters. In that sense, this optimization enhances the security of the rekey process by reducing the complexity and code required.¶
Special thanks go to Valery Smyslov and Antony Antony.¶