patch-2.1.30 linux/include/linux/pt.h

• Lines: 175
• Date: Thu Mar 20 18:17:11 1997
• Orig file: v2.1.29/linux/include/linux/pt.h
• Orig date: Wed Dec 31 16:00:00 1969

diff -u --recursive --new-file v2.1.29/linux/include/linux/pt.h linux/include/linux/pt.h
@@ -0,0 +1,174 @@
+/*
+ * pt.h: Linux device driver for the Gracilis PackeTwin
+ * Copyright (C) 1995 Craig Small VK2XLZ ([email protected].)
+ *
+ * Please read the notice appearing at the top of the file pt.c
+ */
+#define DMA_BUFF_SIZE 2200
+
+#define ON 1
+#define OFF 0
+
+
+/* Register offset info, specific to the PT
+ * E.g., to read the data port on channel A, use
+ *  inportb(pichan[dev].base + CHANA + DATA)
+ */
+#define CHANB   0   /* Base of channel B regs */
+#define CHANA   2   /* Base of channel A regs */
+
+/* 8530 ports on each channel */
+#define CTL 0
+#define DATA    1
+
+#define DMAEN   0x8 /* Offset off DMA Enable register */
+
+/* Timer chip offsets */
+#define TMR0    0x4 /* Offset of timer 0 register */
+#define TMR1    0x5 /* Offset of timer 1 register */
+#define TMR2    0x6 /* Offset of timer 2 register */
+#define TMRCMD  0x7 /* Offset of timer command register */
+#define INT_REG	0x8
+#define TMR1CLR 0x9
+#define TMR2CLR 0xa
+
+/* Interrupt register equates */
+#define PT_SCC_MSK	0x1
+#define PT_TMR1_MSK	0x2
+#define PT_TMR2_MSK	0x4
+
+/* Serial/interrupt register equates */
+#define PT_DTRA_ON	0x1
+#define PT_DTRB_ON	0x2
+#define PT_EXTCLKA	0x4
+#define PT_EXTCLKB	0x8
+#define PT_LOOPA_ON	0x10
+#define PT_LOOPB_ON	0x20
+#define PT_EI		0x80
+
+/* Timer chip equates */
+#define SC0 0x00 /* Select counter 0 */
+#define SC1 0x40 /* Select counter 1 */
+#define SC2 0x80 /* Select counter 2 */
+#define CLATCH  0x00 /* Counter latching operation */
+#define MSB 0x20 /* Read/load MSB only */
+#define LSB 0x10 /* Read/load LSB only */
+#define LSB_MSB 0x30 /* Read/load LSB, then MSB */
+#define MODE0   0x00 /* Interrupt on terminal count */
+#define MODE1   0x02 /* Programmable one shot */
+#define MODE2   0x04 /* Rate generator */
+#define MODE3   0x06 /* Square wave rate generator */
+#define MODE4   0x08 /* Software triggered strobe */
+#define MODE5   0x0a /* Hardware triggered strobe */
+#define BCD 0x01 /* BCD counter */
+
+/* DMA controller registers */
+#define DMA_STAT    8   /* DMA controller status register */
+#define DMA_CMD     8   /* DMA controller command register */
+#define DMA_MASK        10  /* DMA controller mask register */
+#define DMA_MODE        11  /* DMA controller mode register */
+#define DMA_RESETFF 12  /* DMA controller first/last flip flop  */
+/* DMA data */
+#define DMA_DISABLE (0x04)  /* Disable channel n */
+#define DMA_ENABLE  (0x00)  /* Enable channel n */
+/* Single transfers, incr. address, auto init, writes, ch. n */
+#define DMA_RX_MODE (0x54)
+/* Single transfers, incr. address, no auto init, reads, ch. n */
+#define DMA_TX_MODE (0x48)
+
+/* Write registers */
+#define DMA_CFG		0x08
+#define SERIAL_CFG	0x09
+#define INT_CFG		0x09	/* shares with serial config */
+#define DMA_CLR_FF	0x0a
+
+#define SINGLE 3686400
+#define DOUBLE 7372800
+#define XTAL   ((long) 6144000L)
+
+#define SIOCGPIPARAM		0x5000	/* get PI parameters */
+#define SIOCSPIPARAM		0x5001	/* set */
+#define SIOCGPIBAUD		0x5002	/* get only baud rate */
+#define SIOCSPIBAUD		0x5003	
+#define SIOCGPIDMA		0x5004	/* get only DMA */
+#define SIOCSPIDMA		0x5005	
+#define SIOCGPIIRQ		0x5006	/* get only IRQ */
+#define SIOCSPIIRQ		0x5007	
+
+struct pt_req
+{
+	int cmd;
+	int speed;
+	int clockmode;
+	int txdelay;
+	unsigned char persist;
+	int slotime; 
+	int squeldelay;
+	int dmachan;    
+	int irq;    
+};
+
+/* SCC Interrupt vectors, if we have set 'status low' */
+#define CHBTxIV		0x00
+#define CHBEXTIV	0x02
+#define CHBRxIV		0x04
+#define CHBSRCIV	0x06
+#define CHATxIV		0x08
+#define CHAEXTIV	0x0a
+#define CHARxIV		0x0c
+#define CHASRCIV	0x0e
+
+
+#ifdef __KERNEL__
+
+/* Information that needs to be kept for each channel. */
+struct pt_local
+{
+	struct net_device_stats stats; /* %%%dp*/
+	long open_time;             /* Useless example local info. */
+	unsigned long xtal; 
+
+	struct mbuf *rcvbuf;/* Buffer for current rx packet */
+	struct mbuf *rxdmabuf1; /* DMA rx buffer */
+	struct mbuf *rxdmabuf2; /* DMA rx buffer */
+
+	int bufsiz;			/* Size of rcvbuf 			*/
+	char *rcp;			/* Pointer into rcvbuf 			*/
+	struct sk_buff_head sndq;	/* Packets awaiting transmission 	*/
+	int sndcnt;			/* Number of packets on sndq 		*/
+	struct sk_buff *sndbuf;		/* Current buffer being transmitted	*/
+	char *txdmabuf; 		/* Transmit DMA buffer 			*/
+	char *txptr;			/* Used by B port tx 			*/
+	int txcnt;			
+	char tstate;			/* Transmitter state 			*/
+#define IDLE    0       /* Transmitter off, no data pending 		*/
+#define ACTIVE  1       /* Transmitter on, sending data 		*/
+#define UNDERRUN 2      /* Transmitter on, flushing CRC			*/
+#define FLAGOUT 3       /* CRC sent - attempt to start next frame	*/
+#define DEFER 4         /* Receive Active - DEFER Transmit		*/
+#define ST_TXDELAY 5    /* Sending leading flags			*/
+#define CRCOUT 6
+	char rstate;        /* Set when !DCD goes to 0 (TRUE)		*/
+/* Normal state is ACTIVE if Receive enabled */
+#define RXERROR 2       /* Error -- Aborting current Frame		*/
+#define RXABORT 3       /* ABORT sequence detected			*/
+#define TOOBIG 4        /* too large a frame to store			*/
+	
+	int dev;		/* Device number */
+	int base;		/* Base of I/O registers */
+	int cardbase;		/* Base address of card */
+	int stata;		/* address of Channel A status regs */
+	int statb;		/* address of Channel B status regs */
+	int speed;        	/* Line speed, bps */
+	int clockmode;    	/* tapr 9600 modem clocking option */
+	int txdelay;      	/* Transmit Delay 10 ms/cnt */
+	unsigned char persist;  /* Persistence (0-255) as a % */
+	int slotime;		/* Delay to wait on persistence hit */
+	int squeldelay; 	/* Delay after XMTR OFF for squelch tail */
+	struct iface *iface;    /* Associated interface */
+	int dmachan;		/* DMA channel for this port */
+	char saved_RR0;		/* The saved version of RR) that we compare with */
+	int nrzi;		/* Do we use NRZI (or NRZ) */
+};
+
+#endif