patch-2.3.45 linux/drivers/net/znet.c
Next file: linux/drivers/scsi/eata.c
Previous file: linux/drivers/net/wavelan.c
Back to the patch index
Back to the overall index
- Lines: 209
- Date:
Sun Feb 13 10:25:33 2000
- Orig file:
v2.3.44/linux/drivers/net/znet.c
- Orig date:
Wed Aug 18 11:36:43 1999
diff -u --recursive --new-file v2.3.44/linux/drivers/net/znet.c linux/drivers/net/znet.c
@@ -119,10 +119,13 @@
#define CMD0_STAT2 (2 << 5)
#define CMD0_STAT3 (3 << 5)
+#define TX_TIMEOUT 10
+
#define net_local znet_private
struct znet_private {
int rx_dma, tx_dma;
struct net_device_stats stats;
+ spinlock_t lock;
/* The starting, current, and end pointers for the packet buffers. */
ushort *rx_start, *rx_cur, *rx_end;
ushort *tx_start, *tx_cur, *tx_end;
@@ -190,6 +193,7 @@
static void set_multicast_list(struct net_device *dev);
static void hardware_init(struct net_device *dev);
static void update_stop_hit(short ioaddr, unsigned short rx_stop_offset);
+static void znet_tx_timeout (struct net_device *dev);
#ifdef notdef
static struct sigaction znet_sigaction = { &znet_interrupt, 0, 0, NULL, };
@@ -245,6 +249,7 @@
dev->priv = (void *) &zn;
zn.rx_dma = netinfo->dma1;
zn.tx_dma = netinfo->dma2;
+ zn.lock = SPIN_LOCK_UNLOCKED;
/* These should never fail. You can't add devices to a sealed box! */
if (request_irq(dev->irq, &znet_interrupt, 0, "ZNet", dev)
@@ -275,6 +280,8 @@
dev->stop = &znet_close;
dev->get_stats = net_get_stats;
dev->set_multicast_list = &set_multicast_list;
+ dev->tx_timeout = znet_tx_timeout;
+ dev->watchdog_timeo = TX_TIMEOUT;
/* Fill in the 'dev' with ethernet-generic values. */
ether_setup(dev);
@@ -306,41 +313,47 @@
printk(KERN_WARNING "%s: Problem turning on the transceiver power.\n",
dev->name);
- dev->tbusy = 0;
- dev->interrupt = 0;
hardware_init(dev);
- dev->start = 1;
+ netif_start_queue (dev);
return 0;
}
+
+static void znet_tx_timeout (struct net_device *dev)
+{
+ int ioaddr = dev->base_addr;
+ ushort event, tx_status, rx_offset, state;
+
+ outb (CMD0_STAT0, ioaddr);
+ event = inb (ioaddr);
+ outb (CMD0_STAT1, ioaddr);
+ tx_status = inw (ioaddr);
+ outb (CMD0_STAT2, ioaddr);
+ rx_offset = inw (ioaddr);
+ outb (CMD0_STAT3, ioaddr);
+ state = inb (ioaddr);
+ printk (KERN_WARNING "%s: transmit timed out, status %02x %04x %04x %02x,"
+ " resetting.\n", dev->name, event, tx_status, rx_offset, state);
+ if (tx_status == 0x0400)
+ printk (KERN_WARNING "%s: Tx carrier error, check transceiver cable.\n",
+ dev->name);
+ outb (CMD0_RESET, ioaddr);
+ hardware_init (dev);
+ netif_start_queue (dev);
+}
+
static int znet_send_packet(struct sk_buff *skb, struct net_device *dev)
{
int ioaddr = dev->base_addr;
struct net_local *lp = (struct net_local *)dev->priv;
+ unsigned long flags;
if (znet_debug > 4)
- printk(KERN_DEBUG "%s: ZNet_send_packet(%ld).\n", dev->name, dev->tbusy);
-
- /* Transmitter timeout, likely just recovery after suspending the machine. */
- if (dev->tbusy) {
- ushort event, tx_status, rx_offset, state;
- int tickssofar = jiffies - dev->trans_start;
- if (tickssofar < 10)
- return 1;
- outb(CMD0_STAT0, ioaddr); event = inb(ioaddr);
- outb(CMD0_STAT1, ioaddr); tx_status = inw(ioaddr);
- outb(CMD0_STAT2, ioaddr); rx_offset = inw(ioaddr);
- outb(CMD0_STAT3, ioaddr); state = inb(ioaddr);
- printk(KERN_WARNING "%s: transmit timed out, status %02x %04x %04x %02x,"
- " resetting.\n", dev->name, event, tx_status, rx_offset, state);
- if (tx_status == 0x0400)
- printk(KERN_WARNING "%s: Tx carrier error, check transceiver cable.\n",
- dev->name);
- outb(CMD0_RESET, ioaddr);
- hardware_init(dev);
- }
+ printk(KERN_DEBUG "%s: ZNet_send_packet.\n", dev->name);
+ netif_stop_queue (dev);
+
/* Check that the part hasn't reset itself, probably from suspend. */
outb(CMD0_STAT0, ioaddr);
if (inw(ioaddr) == 0x0010
@@ -348,11 +361,7 @@
&& inw(ioaddr) == 0x0010)
hardware_init(dev);
- /* Block a timer-based transmit from overlapping. This could better be
- done with atomic_swap(1, dev->tbusy), but set_bit() works as well. */
- if (test_and_set_bit(0, (void*)&dev->tbusy) != 0)
- printk(KERN_WARNING "%s: Transmitter access conflict.\n", dev->name);
- else {
+ if (1) {
short length = ETH_ZLEN < skb->len ? skb->len : ETH_ZLEN;
unsigned char *buf = (void *)skb->data;
ushort *tx_link = zn.tx_cur - 1;
@@ -385,13 +394,18 @@
zn.tx_cur += rnd_len;
}
*zn.tx_cur++ = 0;
- cli(); {
+
+ spin_lock_irqsave(&lp->lock, flags);
+ {
*tx_link = CMD0_TRANSMIT + CMD0_CHNL_1;
/* Is this always safe to do? */
outb(CMD0_TRANSMIT + CMD0_CHNL_1,ioaddr);
- } sti();
+ }
+ spin_unlock_irqrestore (&lp->lock, flags);
dev->trans_start = jiffies;
+ netif_start_queue (dev);
+
if (znet_debug > 4)
printk(KERN_DEBUG "%s: Transmitter queued, length %d.\n", dev->name, length);
}
@@ -403,6 +417,7 @@
static void znet_interrupt(int irq, void *dev_id, struct pt_regs * regs)
{
struct net_device *dev = dev_id;
+ struct net_local *lp = (struct net_local *)dev->priv;
int ioaddr;
int boguscnt = 20;
@@ -411,7 +426,8 @@
return;
}
- dev->interrupt = 1;
+ spin_lock (&lp->lock);
+
ioaddr = dev->base_addr;
outb(CMD0_STAT0, ioaddr);
@@ -432,7 +448,6 @@
break;
if ((status & 0x0F) == 4) { /* Transmit done. */
- struct net_local *lp = (struct net_local *)dev->priv;
int tx_status;
outb(CMD0_STAT1, ioaddr);
tx_status = inw(ioaddr);
@@ -449,8 +464,7 @@
if ((tx_status | 0x0760) != 0x0760)
lp->stats.tx_errors++;
}
- dev->tbusy = 0;
- mark_bh(NET_BH); /* Inform upper layers. */
+ netif_wake_queue (dev);
}
if ((status & 0x40)
@@ -461,7 +475,8 @@
outb(CMD0_ACK,ioaddr);
} while (boguscnt--);
- dev->interrupt = 0;
+ spin_unlock (&lp->lock);
+
return;
}
@@ -594,8 +609,7 @@
unsigned long flags;
int ioaddr = dev->base_addr;
- dev->tbusy = 1;
- dev->start = 0;
+ netif_stop_queue (dev);
outb(CMD0_RESET, ioaddr); /* CMD0_RESET */
@@ -728,7 +742,7 @@
update_stop_hit(ioaddr, 8192);
if (znet_debug > 1) printk("enabling Rx.\n");
outb(CMD0_Rx_ENABLE+CMD0_CHNL_0, ioaddr);
- dev->tbusy = 0;
+ netif_start_queue (dev);
}
static void update_stop_hit(short ioaddr, unsigned short rx_stop_offset)
FUNET's LINUX-ADM group, [email protected]
TCL-scripts by Sam Shen (who was at: [email protected])