| Internet-Draft | Rate-Limited cwnd Increase | October 2024 |
| Welzl, et al. | Expires 24 April 2025 | [Page] |
This document specifies how transport protocols increase their congestion window when the sender is rate-limited, and updates RFC 5681, RFC 9002, RFC 9260, and RFC 9438. Such a limitation can be caused by the sending application not supplying data or by receiver flow control.¶
This note is to be removed before publishing as an RFC.¶
The latest revision of this draft can be found at https://mwelzl.github.io/draft-ccwg-ratelimited-increase/draft-welzl-ccwg-ratelimited-increase.html. Status information for this document may be found at https://datatracker.ietf.org/doc/draft-welzl-ccwg-ratelimited-increase/.¶
Discussion of this document takes place on the Congestion Control Working Group Working Group mailing list (mailto:[email protected]), which is archived at https://mailarchive.ietf.org/arch/browse/ccwg/. Subscribe at https://www.ietf.org/mailman/listinfo/ccwg/.¶
Source for this draft and an issue tracker can be found at https://github.com/mwelzl/draft-ccwg-ratelimited-increase.¶
This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶
Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶
Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶
This Internet-Draft will expire on 24 April 2025.¶
Copyright (c) 2024 IETF Trust and the persons identified as the document authors. All rights reserved.¶
This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶
A sender of a congestion controlled transport protocol becomes "rate-limited" when it does not send any data even though the congestion control rules would allow it to transmit data. This could occur because the application has not provided sufficient data to fully utilise the congestion window (cwnd). It could also occur because the receiver has limited the sender using flow control (e.g., by the advertised TCP receiver window (rwnd) or by the connection or stream flow credit in QUIC). Current RFCs specifying congestion control algorithms diverge regarding the rules for increasing the cwnd when the sender is rate-limited.¶
Congestion Window Validation (CWV) [RFC7661] provides an experimental specification defining how to manage a cwnd that has become larger than the current flight size. In contrast, this present document concerns the increase in cwnd when a sender is rate-limited. These two topics are distinct, but are related, because both describe the management of the cwnd when the sender does not fully utilise the current cwnd.¶
This document specifies a uniform rule that congestion control algorithms MUST apply and provides a recommendation that congestion control implementations SHOULD follow. An appendix provides an overview of the divergence in current RFCs and some current implementations regarding cwnd increase when the sender is rate-limited.¶
This document uses the terms defined in Section 2 of [RFC5681]. Additionally, we define:¶
maxFS: the largest value of FlightSize since the last time that cwnd was decreased. If cwnd has never been decreased, maxFS is the maximum value of FlightSize since the start of the data transfer.¶
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.¶
Irrespective of the current state of a congestion control algorithm, senders using a congestion controlled transport protocol:¶
MUST include a limit to the growth of cwnd when FlightSize < cwnd.¶
SHOULD limit cwnd when FlightSize < cwnd to be no larger than limit(maxFS).¶
MAY limit maxFS as min(maxFS, pipeACK), using "pipeACK" as defined in [RFC7661], when FlightSize < cwnd.¶
In rule #2, "limit()" is a function that returns the maximum cwnd value that would result from the congestion control algorithm within one RTT, based on the "maxFS" parameter. For example, for Slow Start, as specified in [RFC5681], limit(maxFS)=2*maxFS, such that equation 2 in [RFC5681] becomes:¶
cwnd_new = cwnd + min (N, SMSS) cwnd = min(cwnd_new, 2*maxFS)¶
Similarly, with rule #2 applied to Congestion Avoidance, limit(maxFS)=1+maxFS, such that equation 3 in [RFC5681] becomes:¶
cwnd_new = cwnd + SMSS*SMSS/cwnd cwnd = min(cwnd_new, 1+maxFS)¶
As with cwnd, without a way to reduce it when the transport sender becomes rate-limited, rule #2 allows for maxFS to stay valid for a long time, possibly not reflecting the reality of the end-to-end Internet path in use. For cwnd, this is remedied by "Congestion Window Validation" in [RFC7661], which also defines a "pipeACK" variable that measures the acknowledged size of the network pipe when the sender is rate-limited. Accordingly, to implement CWV, rule #3 can be used.¶
If the sending rate is less than permitted by cwnd for multiple RTTs, limited either by the sending application or by the receiver-advertised window, continuously increasing the cwnd would cause a mismatch between the cwnd and the capacity that the path supports (i.e., over-estimating the capacity). Such unlimited growth in the cwnd is therefore disallowed by the first rule.¶
However, in most common congestion control algorithms, in the absence of an indication of congestion, a cwnd that has been fully utilized during an RTT is permitted to be increased during the immediately following RTT. Thus, such an increase is allowed by the second rule.¶
The present document updates congestion control specifications that use a congestion window (cwnd) to limit the number of unacknowledged packets a sender is allowed to emit. Use of a congestion window variable to control sending rate is not the only mechanism available and used in practice.¶
Congestion control algorithms can also constrain data transmission by explicitly calculating the sending rate over some time interval, by "pacing" packets (injecting pauses in between their transmission) or via combinations of the above (e.g., BBR combines these three methods [I-D.cardwell-iccrg-bbr-congestion-control]). The guiding principle behind the rules in Section 3 applies to all congestion control algorithms: in the absence of a congestion indication, a sender should be allowed to increase its rate from the amount of data that it has transmitted during the previous RTT. This holds irrespective of whether the sender is rate-limited or not.¶
Pacing mechanisms seek to avoid the negative impacts associated with "bursts" (flights of packets transmitted back-to-back). This is usually without limiting the number of packets that are sent per RTT. The present specification introduces a limitation using "maxFS", which is measured over an RTT; thus, as long as the number of packets per RTT is unaffected by pacing, the rules in Section 3 also do not constrain the use of pacing mechanisms.¶
While congestion control designs could result in unwanted competing traffic, they do not directly result in new security considerations.¶
Transport protocols that provide authentication (including those using encryption), or are carried over protocols that provide authentication, can protect their congestion control algorithm from network attack. This is orthogonal to the congestion control rules.¶
This document requests no IANA action.¶
This section is provided as input for IETF discussion, and should be removed before publication.¶
[RFC5681] does not contain a rule to limit the growth of cwnd when the sender is rate-limited. This statement (page 8) gives an impression that such cwnd growth might be expected:¶
Implementation Note: An easy mistake to make is to simply use cwnd, rather than FlightSize, which in some implementations may incidentally increase well beyond rwnd.¶
[RFC7661] also suggests there is no increase limitation in the standard TCP behavior (which [RFC7661] changes), on page 4:¶
Standard TCP does not impose additional restrictions on the growth of the congestion window when a TCP sender is unable to send at the maximum rate allowed by the cwnd. In this case, the rate-limited sender may grow a cwnd far beyond that corresponding to the current transmit rate, resulting in a value that does not reflect current information about the state of the network path the flow is using.¶
ns-2 allows cwnd to grow when it is rate-limited by rwnd. (Rate-limited by the sending application: not tested.)¶
Until release 3.42, ns-3 allowed cwnd to grow when rate-limited, either due to an application or rwnd limit. Since release 3.42, ns-3 TCP models conform to rule #2 in Section 3, following the current Linux TCP approach in this regard (see next bullet).¶
In Congestion Avoidance, Linux only allows the cwnd to grow when the sender is unconstrained.
Before kernel version 3.16, this also applied to Slow Start.
The check for "unconstrained" is perfomed by checking if FlightSize is greater or equal to cwnd.
Since kernel version 3.16, which was published in August 2014, in Slow Start, the increase
implements rule #2 in Section 3 in the tcp_is_cwnd_limited function in tcp.h.¶
Linux implements a limit to cwnd growth in accordance with rule #1 in Section 3; in Slow Start, this limit follows rule #2, while in Congestion Avoidance, it is more conservative than rule #2. The specification and the ns-2 and (older) ns-3 implementations are in conflict with rules #1 and #2 in Section 3.¶
Section 5.8 of [RFC9438] says:¶
Cubic doesn't increase cwnd when it's limited by the sending application or rwnd.¶
The description of Linux described in Appendix A.1.2 also applies to Cubic.¶
Section 7.2.1 of [RFC9260] says:¶
When cwnd is less than or equal to ssthresh, an SCTP endpoint MUST use the slow-start algorithm to increase cwnd only if the current congestion window is being fully utilized and the data sender is not in Fast Recovery. Only when these two conditions are met can the cwnd be increased; otherwise, the cwnd MUST NOT be increased.¶
The quoted statement from [RFC9260] prescribes the same cwnd growth limitation that is also specified for Cubic and implemented for both Reno and Cubic in Linux. It is in accordance with rule #1 in Section 3, and more conservative than rule #2 in Section 3.¶
Section 7.2.1 of [RFC9260] is specifically limited to Slow Start. Congestion Avoidance is discussed in Section 7.2.2 of [RFC9260] However, this section neither contains a similar rule, nor does it refer back to the rule that limits the growth of cwnd in Section 7.2.1. It is thus implicitly clear that the quoted rule only applies to Slow Start, whereas the rules in Section 3 apply to both Slow Start and Congestion Avoidance.¶
Section 7.8 of [RFC9002] states:¶
When bytes in flight is smaller than the congestion window and sending is not pacing limited, the congestion window is underutilized. This can happen due to insufficient application data or flow control limits. When this occurs, the congestion window SHOULD NOT be increased in either slow start or congestion avoidance.¶
With the exception of pacing, this specification conservatively limits the growth in cwnd, similar to Cubic and SCTP. It is in accordance with rule #1 in Section 3, and more conservative than rule #2 in Section 3.¶
Section 5.1 of [RFC4341] states: >There are currently no standards governing TCP's use of the congestion window during an application-limited period. In particular, it is possible for TCP's congestion window to grow quite large during a long uncongested period when the sender is application limited, sending at a low rate. [RFC2861] essentially suggests that TCP's congestion window not be increased during application-limited periods when the congestion window is not being fully utilized.¶
A DCCP Congestion Control ID (CCID) specifing TCP-like behaviour ought to follow the method specified in this document. The current guidance relates only to [RFC2861]. The text in Section 5.1 of [RFC4341] is updated by this document to specify the management of the cwnd during an application-limited period.¶
-00 was the first individual submission for feedback by CCWG.¶
-01 includes editorial improvements¶
-02 addresses comments from IETF-119¶
-03 addresses comments from IETF-120¶
Introduces a third rule, with MAY, that avoids having an unvalidated long-lived maxFS (using pipeACK from RFC 7661).¶
Changes "inc" to "limit" and adapts the wording of rule 2 to make it clearer (thanks to Neal Cardwell).¶
Appendix: updates ns-3 in line with the recent implementation.¶
Appendix: makes the RFC 9002 text clearer and shorter.¶
The authors would like to thank Neal Cardwell for suggesting improvements to this document.¶